Many Thanks Card Kit Tutorial

Craft Time: ~1.5 hours total (~15 minutes per card)

Fold the card along the score line, with the small bump on the inside. Use the bone folder for a crisp fold.
Prepare the glue bottle: Open the lid, remove the stopper, and screw the valve cap back on.
Use a small amount of glue to prevent paper warping.
Lay out all pieces before attaching them. Follow the steps below for the correct layering order.
Foam adhesives: Use wherever you’d like to add dimension.
Inside sentiments: These are optional. Add them if you’d like!

Glue the embossed panel to the center of the card front.
Glue the dark green leaf piece to the embossed panel, covering the outline.
Glue the “Thank You” piece to the light green leaf piece. Attach the finished layered piece to the dark green leaf piece using foam adhesive.
Add three clear enamel dots wherever you’d like.

Glue each letter of “Thanks” over its outline. Set aside.
Glue piece #2 on top of piece #1. Glue the finished layered piece to the card front, adding small dots of glue to the leaves to keep them secure.
Attach the pink flowers over their outlines using foam adhesive.
Attach the “Thanks” piece over its outline on piece #2 using foam adhesive.
Add three clear enamel dots wherever you’d like.

Glue the white die-cut panel to the card front, with the thin gray placement guide toward the bottom. Add small dots of glue to the points to keep them secure.
Attach the “Thanks So Much” piece using foam adhesive, positioning the word “Much” inside the gray placement guide.
Attach the three flowers wherever you’d like using foam adhesive.
Add a white enamel circle to the center of each flower.

Attach each flower over its outline using foam adhesive.
Glue the “Thankful for You” piece over its green outline.
Add a yellow enamel center to each of the four large flowers.
Add three clear enamel dots wherever you’d like.
If adding the optional inside sentiment, place it low enough that it doesn’t show when the card is closed.

Glue the “Just Wanted to Say…” piece to the card front, covering the third line from the bottom.
Fold the blue rectangular piece along all score lines. Remove the adhesive backing, add a few small dots of glue, and fold it into a rectangular box. Set aside to dry.
Glue piece #2 on top of piece #1.
Glue the white crate on top of piece #2, then glue the “Thank You” piece to the top bar of the crate.
Attach each flower over its outline using foam adhesive.
Glue the blue rectangular box inside the card, following the outline. Add glue to both sides, then close the card and press firmly to secure it and ensure it folds properly.
Once dry, glue the finished flower crate to the front of the pop-up box.